BUILDING THE WORDEN GRINDER

Part 14 by Vince Cutajar - conclusion

Completed the final assembly and some tweaking to get the wheel parallel to the work table before dressing.

Took some final shots before I start scratching it.

A shot of the diamond dresser after the operation was completed.
A little-used HSS cutter that had seen better times was ground the other end to make a knife tool as per instructions.

Grinding one of the faces at 20 degrees.

Grinding the front face of the tool.
And the finished tool.
I was surprised how smooth the ground faces came out.  I just gave it a quick lap on a stone to remove the burrs.


Part one here  Part two  Part three  Part four  Part five  Part six  Part seven  Part eight  Nine  10  11  12  13  14